A flawless polished‑concrete look— installed fast, over new or existing floors.
Fast, flat, and flooring-ready. LEVELCORE TruLevel is a high-flow, polymer-modified self-levelling screed engineered to deliver high compressive strength and a smooth finish for interior flooring systems.
Ideal for: resilient flooring, LVT, tile, timber and carpet systems over properly prepared internal substrates.
A fast‐drying, self‐levelling, polymer modified, abrasion resistant, cementitious underlayment prior to applying floor finishes. It is a pourable and flowable mortar for use where a level surface is necessary prior to installing floor coverings.
41.9 Mpa
4 – 6 hours
Approx. 24 hours at <10mm
1–30mm
*Actual times vary with temperature, humidity, substrate, and thickness
Start thickness 3 mm
Rapid return to service reduces program risk and downtime.
High flow and self‑levelling rheology minimize trowel marks and pinholes.
From feather‑to‑finish patches to full‑room pours up to 30 mm (single lift).
Compatible with in‑slab/radiant heating and most common floor coverings.
Optimized for batch mixing or continuous pumping
Smooth, dense surface that helps adhesives and coverings perform.
4.8-4.9 L
2-3 minutes to a lump-free, pourable consistency
pour or pump; spread with gauge rake; de-air with spike roller immediately
protect from drafts, direct sun, and rapid moisture loss
Safety: Contains cement. Alkaline when wet. Wear gloves, eye protection, and a suitable mask/respirator during mixing. See SDS.
Mechanically clean and sound; prime to consolidate surface and
reduce pinholes.
Mechanical prep to suitable profile; use a compatible bonding
primer.
Only where structurally adequate and per local code; prime/seal appropriately.
Switch off 24 hours prior; restart per commissioning schedule after cure.
Moisture: test per local standards. If above limits for adhesives/coverings, install an appropriate moisture mitigation system before priming
A fast‐drying, self‐levelling, polymer modified, abrasion resistant, cementitious underlayment prior to applying floor finishes. It is a pourable and flowable mortar for use where a level surface is necessary prior to installing floor coverings.
For safety information, handling instructions, and regulatory details, please download the Safety Data Sheet (SDS) using the button below.
For detailed technical specifications, application guidelines, and performance data, please download the Technical Data Sheet (TDS) from the button below.
VOC Emissions Test Report
Third-party laboratory results for VOC emissions/IAQ compliance evidence. Use this document for specification and project submission requirements.
TruLevel can be covered under the LevelCore 10-Year System Warranty when warranty requirements are met, including:
QA submissions:
Submit QA forms and media within 5 working days via the Levelcore Portal or email.
Warranty contacts:
warranty@levelcore.com.au | 1800 717 398
Typically around 24 hours at < 10 mm under standard conditions; thicker pours require longer. Always verify substrate moisture and adhesive requirements
Yes. Follow the heat-up / cool-down protocol and allow appropriate cure before commissioning.
1–30mm. For deeper sections, extend with graded aggregate per guidance and pour in controlled lifts.
Yes – use an approved primer to improve bond and control absorbency. Confirm the correct primer / system in the TDS/specification.
